Europlex 3GS Installation Guide download pdf (Page 46)

PROGRAMMING THE PANEL cont.

SINGLE-ZONE MONITOR - This option allows the user to examine any zone and display its

state and analogue value. Once the zone number is entered, say 14, and the RETURN key

pressed, it is possible to increment [press the FULL DISARM (+) key] or decrement [press the

AUDIBLE SILENCE 1 (-) key] the zone number without having to exit and re-enter this option.

The display is shown as follows:

AREA-1 14 CLOSED [28], if the input is On Line

AREA-1 14 CLOSED *28*, if the input is Not On Line

AREA-1 14 CLOSED /28/, if the input is Disabled

*AREA-1 14 CLOSED [28], if the input is Manually Shunted

/AREA-1 14 CLOSED [28], if the input is Program Shunted

+AREA-1 14 CLOSED [28], if the input is both Manually & Program Shunted

L The analogue value displayed will increase on systems with long cable runs due to wire

resistance and to a lesser extent increased cable capacitance.

The piezo-sounder is used in this option to indicate the state of the LEM input under test. The

relationship between the beeping sound and the state of the input is as follows:

STATE OF INPUT PIEZO-SOUNDER

CLOSED Off

OPEN Long beep

SHORT Short beep

DISCON Continuous

NOTES:

1. The piezo-sounder may be turned off by pressing the AUDIBLE SILENCE 2 key. Press

this key again to re-enable the piezo-sounder.

2. The zone description for any zone may be displayed by pressing the HELP key.

3. As in the WALKTEST option above, you may press the FULL ARM key and TIMED

BELL panel relay output 7 will trip briefly every time the displayed zone changes state.

TROUBLE-SHOOTING INPUT LOOPS:

The following section is included to give the installer guidance in trouble-shooting zone inputs.

Zone 5 (an odd numbered zone, therefore connected to terminals 6 and 7 of a LEM addressed

to 3) has been chosen.

PROGRAMMING THE PANEL cont.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 86 87

No comments

Europlex 3GS Installation Guide Page 46